FROG Pool Bac Pac


Pool Frog’s Bac Pac Pre-filled cartridges provide pool owners with a way to supply chlorine to their systems slowly and steadily, enabling maximum chlorine effectiveness.  No mess, no guess, no stress.

Each Bac Pac contains 2.2 lbs. of trichlor tablets.


Adjust pH to 7.2-7.8

Bring Free Available Chlorine residual to 1.0 ppm using a
chlorine shock.

Stabilize the pool with a cyanuric acid stabilizer.

Take off colored caps

Hold pack so open end faces down, and insert into reservoir.

The end of the cap must align with the key located inside the FROG cycler on the bottom.

To Install Bac Pac: Take Pool Frog Cycler cap off. Remove pac colored caps. Hold pac so the open end faces down. Insert into Pool Frog Mineral Reservoir. The end of the pac must align with the key located inside the Pool Frog Cycler at the bottom. Do not force. Replace the feeder cap and set the control dial per the size and pump run time of your pool according to the chart in the manual included with the the Pool Frog Mineral Reservoir. Monitor chlorine level daily for the first week to determine correct dial setting. Turn the control dial to the next higher setting to increase the free available chlorine and turn it to the next lower setting to lower the free available chlorine. Check the free available chlorine residual and increase/decrease one setting per day until you have achieved at least 0.5 ppm

This product is compatible with chlorine, salt chlorine generators, ozone and the FROG® brand of mineral systems.

FROG® is a brand of mineral sanitizing systems for swimming pools and hot tubs. This patented and EPA registered product creates Fresh Mineral Water® that is Cleaner because it kills bacteria two ways, Clearer because it helps keep the pH in line for better water clarity, Softer as it conditions the water and uses up to 50% less chlorine and Easier to use with pre-filled pacs for no mess, no guess and no stress water care.